برد شیلد درایور CNC-V3

شیلد درایور CNC ورژن 3 قابل نصب بر روی برد اردینو UNO R3 را دارد و از 4 محور و برنامه GBRL پشتیبانی میکند
:CNC Shield Board
Latest CNC Shield Version 3
(0.9 compatible. GRBL (open source firmware that runs on an uno that turns the G-code commands into stepper 37signals
PWM Spindle and direction pins
(4-Axis support (X, Y, Z, A-Can duplicate X, Y Z, or do a full 4th axis with custom firmware using pins D12 and D13
(2 x End stops for each axis (6 in total
Coolant enable
Uses removable A4988 or DRV8825 compatible stepper drivers
(Jumpers to set the Micro-Stepping for the stepper. (some drivers like the DRV8825 can do up to 1 / 32 micro-stepping
Compact design
Stepper Motors can be connected with pin Molex connectors or soldered 4 in place
(Runs on 12-36v DC. (at the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the